Is it possible to jump start a motorcycle with a car
The reason is that invariable final connections cause a spark, and it may result in an explosion and not just flames. Besides, a lead-acid battery in typical internal combustion vehicles produces hydrogen gas during the work cycle. Not being careful can result in burns, and it is worse when the spark is closer to fuel or hydrogen gas. Yes, you can jumpstart a motorcycle with a car battery.
A typical car battery has a higher amperage than a motorcycle battery, making it possible to jumpstart your motorcycle using a car battery. However, you must not make it a habit to jumpstart your motorbike using a car battery always; it must be during emergencies only. Note that this practice can damage or degrade your motorcycle components and void the warranty on the battery.
Regardless of the dangers, you can jumpstart your bike safely with a car battery. What you require is a jumper cable to jumpstart the motorcycle with your car. First, turn off the ignitions on the car and motorcycle. It is important to disable ignitions on both motor vehicles to prevent ruining the voltage regulator or motorcycle battery. Next, connect one of the red jumper cable clamps to the positive terminal of the battery of your motorcycle.
The red jumper cable clamps must be connected to the red positive terminal on the motorcycle battery. Note that positive goes to positive.
On the car battery, connect the near the car to the negative post. Note that the negative posts in most new cars sit several inches away from the battery. After connecting the black clamp near the negative post of the car, the jumper cable is energized, and you must handle it cautiously.
Now, connect the black clamp near your motorbike to an unpainted area on the motorcycle frame. Skip this step if you intend to replace the battery Plug in and recharge your jump-starter. If your bike starts, ride it around for minutes to recharge your dead battery. If you intend to replace the battery, you can skip this step and just ride to your mechanic. Note: Both motorcycle and car should be switched off as you begin.
Information About us Contact us Advertise with us How we review products. Start the motorcycle. Unless the battery is totally gone, it should start right up. Let it run a few minutes to warm up the motorcycle engine before disconnecting the jumper cables. Disconnect the jumper cables in the reverse of the order you connected them Steps 2 and 3. Be careful to keep the clamps from touching anything metal until the cables are fully disconnected.
Leave the motorcycle running until you drive it home or to a bike shop to get a new battery or a proper recharge. He writes about business, personal finance and careers. Sources: Yuasa , Motorcyclist. Home Features Ask RideApart. May 18, at pm ET.
By : Janaki Jitchotvisut. Got a tip for us? Email: tips rideapart.
0コメント